General Information Sunrise07:00
Sunset20:02
Temp. Outside16.3 °C
Temp. Inside20.9 °C

Usages for today Gas0,67 m3
Power5,5 kWh
Water205 L

HA Statistics Interfaces 18
Devices 143
Info items 520
Uptime 2 10:50
Avg CPU load (%) 0,37
Mem size 939 k
Mem count 20680

Hot Projects

Read about them on my web log:

DIY Wireless Sensors ZigBee Proliphix thermostat Arduino Visonic receiver

Last page added:

ZigBee Network Lux Sensor

Current status of motion detectors

Motion detection
Location	Value	LastChange
Bathroom	no motion	10-9-2010 7:32:21
Bedroom	no motion	10-9-2010 7:27:26
Bedroom Esther	no motion	10-9-2010 7:26:41
Bedroom Remco	no motion	10-9-2010 7:14:23
Entrance-V	no motion	10-9-2010 8:04:05
Garage	no motion	10-9-2010 7:41:28
Garage-V	no motion	10-9-2010 7:52:03
Kitchen	no motion	10-9-2010 8:00:59
Living Back	no motion	10-9-2010 6:53:10
Livingroom	no motion	10-9-2010 8:00:53
Office-V	no motion	10-9-2010 7:31:58
Passage	no motion	15-8-2010 22:48:00
Plugwise.Test	no motion	6-9-2010 14:19:34
Scullery	no motion	10-9-2010 7:59:10
Stairs	no motion	10-9-2010 7:42:03
Wash & Dryer	no motion	10-9-2010 6:59:15

I have several types of motion detectors in our house. There are MS13 motion sensors that have a PIR for detecting motion. The MS13 sensors operate on 433 MHz and are received by my 2 RFXCOM Receivers. But I also use Visonic PIR motion detectors. Those sensors operate on 868 MHZ, but for those i have a special RFXCOM Visonic receiver.

Marmitek MS13E

Visonic K9-80 MCW

Visonic NEXT PIR MCW

And i have 2 KAKU AWST-6000 motion sensors, they work fine but have the problem that they send a lot of packets (35!) when motion is detected. That's a lot!

KlikAanKlikUit AWST-6000